Garrett Boon 
This tower was 24 inches tall, 6 inches wide at the base, tapering to a 1 & 1/2 inch square at the middle. This tower weighed 7.0 grams, and held 11kg for 2nd place at the 2005 GA Science Olympiad State Finals. I am in the middle of building a tower for my Science Olympiad … Read more
An L-beam is more efficient than a square the same width. It is not going to hold as much, but it is going to be more efficient. An L-beam is also more efficient than a square with the same mass of wood. Of course, you have to count in the glue weight for an L-beam.Balsa, … Read more
Bridges must be able to withstand several types of forces. The two most common to model bridges are compression and tension, pushing and pulling respectively. The other two are torsion (twisting) and shear. Learn what these forces mean so that you can build a better model bridge.
We had some of our cousins spend the weekend with us. After the initial greetings, Matt asked me, “Can we go finish the bridge?” We had started building a bridge last year, when they came over to visit. Matt had finished one side of the bridge. While I did help him design it, Matt did … Read more
The Bridge Builder Poem An old man, going a lone highway, Came, at the evening, cold and gray, To a chasm, vast, and deep, and wide, Through which was flowing a sullen tide. The old man crossed in the twilight dim; The sullen stream had no fears for him; But he turned, when safe on … Read more
If you have read my bio page, then you already know a little bit about my bridge building experiences. But today I want to share some more behind why I created GarrettsBridges.com. The only reason I got involved in model bridge building was because of my activity in Science Olympiad. Before that, I simply had … Read more
The type of joint you use on your bridge can drastically change its strength. There are three basic types of joints, the Lap Joint, End Joint, and Notched Joint. To increase the strength of an end or notched joint you can add a Gusset. Learn about each type of joint and when to use it on a model bridge in this article.
I built this bridge for the 2005 Fernbank Science Center bridge design event. The bridge spanned 16 inches, weighed 37 grams, and held 346 pounds. That puts its efficiency over 4200! One commenter said, “So if this bridge weighed one pound, it could have held up my car.”
Many people come to Garretts Bridges looking for advice on building a toothpick bridge. And though I have thought much about it, I have not attempted to build one yet. Here is a father who’s son made a toothpick bridge. He discusses how to design and build a toothpick bridge, and also has good photos. … Read more
This popsicle stick bridge was made from 40, unmodified popsicle sticks. The bridge spanned 12 inches, was 4 inches tall and 3 inches wide. I used only Elmer’s white glue to build the bridge. It weighed 57.4 grams (0.13 pounds), and held 90 pounds. Its efficiency score was 712.